3D Printing Software Controllers

Home Forums General 3D Printing Software Controllers

This topic contains 1 reply, has 1 voice, and was last updated by  Paul 3 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1205

    Paul
    Keymaster

    I know Jim is very familiar with Pronterface and we’ve had a few members try out ReplicatorHost.

    Anyone else ever try some of the other available software controllers? Such as Cura or Makerware… I’d be interested in hearing your experiences in regards to these other pieces of software vs the standard Pronterface setup.

    #1206

    Paul
    Keymaster

    Here is a post on others trying out Cura (with their settings in post) and apparently with great results…

    Might be worth checking out…

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.